*** Note, if you plan to use epoxy on the front of your artist panel, the back of the panel also should be coated with epoxy before front application to avoid warping.
- Eliminates need to pre-form a surface.
- Consistent repeatable patterns made with CNC router.
- Wide range of patterns allow unlimited creativity.
- No more sagging canvas backgrounds.
Hanging your panel can be done in a couple of ways.
One Suggestion is to epoxy on a piece of wood toward the top of the panel, and then affixed to that piece of wood can be our wire hanging kit or a Hangman Hanger.
Note - Do not put screws directly into the panel for risk of piercing your artwork.
EZ Forms Included - Shop EZ Forms Separately Here
Use EZ Forms to hold epoxy on sculpted panels to avoid spillage with your initial layers. EZ Forms are removed before your final pour. To use, simply coat the white side of the EZ Form with a mold release product of your choice. Fasten the easy form to your panel with a high-quality duct. Apply epoxy layers. Remove EZ Forms prior to your final epoxy pour.
Hanging your panel can be done in a couple of ways.
One Suggestion is to epoxy on a piece of wood toward the top of the panel, and then affixed to that piece of wood can be our wire hanging kit or a Hangman Hanger.
Note - Do not put screws directly into the panel for risk of piercing your artwork.
| Add the Wire Hanging Kit for up to 25lbs for $12.05 Click Here to Learn about the Hanging Kit |
 |
|
| Add the 2 Quart Table Top Epoxy for $65.75 Click Here to Learn about our Epoxy Products |
 |
|
| Add the Wall Dog Safety Hanger for wired pictures for $4.49. Click Here to Learn about our Hangman Hanging Solutions |
 |
Check out our selection of Glitter products for your Epoxy project |
 |
Check out our selection of Pigment/Tint products for your Epoxy project |
 |
Contact 
Help
Home
Wishlist
Account
Cart