/>
  • faq
  • email Contact
  • help Help
Navigation

4" Brass Spade Clock Hands

Average rating:
average rating 96%
6 reviews
Explore all reviews
Quantity   1 - 9     10 - 49     50+  
Price $2.50 $2.00 $1.75
Per Set of Clock Hands
US NO TAX, Part #: QH-957
Quantity: 
 
Checkout/Estimate Shipping
Share Share on Facebook Share on Pinterest

4" Hands - Spade - Brass

This pair of “spade” style 4” hour and minute hands is available in black or brass. The brass hands are made of a brass clad steel.  These clock hands have an American “I” shaft configuration.
     
      • Recommended for use with Mini Movements 
 
      • Includes the Hour and Minute Hand
 
     
Average rating:
average rating 96%
6 reviews

Write a Review || Explore all reviews

Featured positive reviews:

average rating 100%
Just what we needed 01/04/2021
By Ruthie B
We ordered these parts for a clock we’d had for awhile that the motor had died. I had looked for quite awhile for new parts and had even ordered a few that didn’t fit what we needed. I found Bear Woods just searching online and it turned out to be just what we needed. Good quality at a reasonable cost.
average rating 80%
Back in service 08/08/2021
By Dick Chapin
Everything worked great, but the second hand did not fit. I still put the clock back in service, as the second hand was not critical to operation in this instance. Would have been nice to have, but ~ ~ ~ ~
average rating 100%
great quality at e reasonable price 03/10/2020
By Alvie Ramey
the products quality and price are reason for me to order if I need to order any clock parts
average rating 100%
clock hands 03/17/2019
By Joyce
Just right for our clock. Great inventory & service. Thanks.
average rating 100%
happy customer 12/26/2022
By Donna Rosen
Just what we ordered. Good quality and fast shipping.
average rating 100%
Clock handa 11/29/2018
By Bob McDonald
Good thanks
 
Tips

how to choose clock movements and hands

How do I choose the right size clock motor & hands? 
1) Refer to the figure here, or Click Here for helpful info (a new window or tab will open)  

2) The size of hands is based on the length of the minute hand from the mounting hole to the end of the minute hand. (Figures 3 & 4) 

3) Our clock motors are sized by the thickness of the dial the movements can go through.  EG. High torque Q-64 will go through up to 5/8" thick material, while standard/mini motor Q-11 will go through 1/8" thick clock faces. (Figure 1 and  item "A" in Figure 2)


Tip 1)  If your material is too thick, consider removing some to in-set the clock.  Or if your clock face material is too thin, consider adding some material behind the face so the hands will sit closer to your clock face. 

Tip 2) Most hands can be slightly trimmed if need be.

Tip 3) Our customers also spray paint them. 

Check out some of our best-sellers!